Measured into 50 Ohms
| Output | |
|---|---|
| Maximum Value | 850 volts |
| Minimum Value | 0 volts |
| Maximum Current | 17 amperes (850V/50 Ohms) |
| Means of Adjustment | Controlled by input high voltage |
| Connector Type | BNC, side panel |
| High Voltage Input | |
| Maximum Value | 950 volts DC |
| Minimum Value | 0 volts DC |
| Connector Type | Type N, side panel |
| Output Pulse Characteristics | |
| Pulse Rise Time | Negative Polarity: 6ns @ 850V (10-90%) Positive Polarity: 10ns @850V (10-90%) |
| Pulse Width | 55ns to 10µs, controlled by input trigger |
| Pulse Recurrence Frequency | Single shot to 1MHz, 5MHz burst, controlled by input trigger |
| Over/undershoot | < 5% |
| Jitter | < 100ps shot-to-shot |
| Delay Between Gate and Output Pulse | < 40ns |
| Gate | |
| Gate Source | External |
| Gate Input | +5V ±1V into 50 Ohms |
| Gate Rise Time | < 6ns |
| Connector Type | BNC, side panel |
| General | |
| Input AC Power | 110/220VAC 50/60Hz, factory set |
| Dimensions: | 8.32"L x 4.22"W x 1.72"D |
| Weight: | Approximately 3.5lbs |
| Specifications subject to change without notice. | |
| Ordering: HV1000 is the part number and description. Output polarity is factory set. When ordering, please specify positive or negative polarity and AC line voltage. |
|
| Note: The user controls the voltage on the external power supply, therefore proper precautions must be taken by the user not to exceed the maximum 950V input voltage rating. The user must take proper precautions to avoid short circuits in the output. The extremely fast speed of the MOSFET switch in the HV1000 precludes the use of conventional current sensing/feedback loop short circuit protection. |
|
 |
| Minimum Pulse Width, 20ns/div, Vin=950V, RL = 50 Ohms |
| |
 |
| 4.5 MHz Burst; 900V into 50 Ohms |
